NAME¶

i2cdetect - detect I2C chips

SYNOPSIS¶

i2cdetect [-y] [-a] [-q|-r] i2cbus [first last]
i2cdetect -F i2cbus
i2cdetect -V
i2cdetect -l

DESCRIPTION¶

i2cdetect is a userspace program to scan an I2C bus for devices. It outputs a table with the list of detected devices on the specified bus. i2cbus indicates the number or name of the I2C bus to be scanned, and should correspond to one of the busses listed by i2cdetect -l. The optional parameters first and last restrict the scanning range (default: from 0x03 to 0x77).

As there is no standard I2C detection command, i2cdetect uses arbitrary SMBus commands (namely SMBus quick write and SMBus receive byte) to probe for devices. By default, the command used is the one believed to be the safest for each address. See options -q and -r to change this behavior.

i2cdetect can also be used to query the functionalities of an I2C bus (see option -F.)

WARNING¶

This program can confuse your I2C bus, cause data loss and worse!

INTERPRETING THE OUTPUT¶

Each cell in the output table will contain one of the following symbols:

• "--". The address was probed but no chip answered.
• "UU". Probing was skipped, because this address is currently in use by a driver. This strongly suggests that there is a chip at this address.
• An address number in hexadecimal, e.g. "2d" or "4e". A chip was found at this address.

OPTIONS¶

-y

Disable interactive mode. By default, i2cdetect will wait for a confirmation from the user before messing with the I2C bus. When this flag is used, it will perform the operation directly. This is mainly meant to be used in scripts.

-a

Force scanning of non-regular addresses. Not recommended.

-q

Use SMBus "quick write" command for probing. Not recommended. This is known to corrupt the Atmel AT24RF08 EEPROM found on many IBM Thinkpad laptops.

-r

Use SMBus "receive byte" command for probing. Not recommended. This is known to lock SMBus on various write-only chips (most notably clock chips at address 0x69).

-F

Display the list of functionalities implemented by the adapter and exit.

-V

Display the version and exit.

-l

Output a list of installed busses.

EXAMPLES¶

List all available I2C busses:

# i2cdetect -l

Immediately scan the standard addresses on I2C bus 9 (i2c-9), using the default method for each address (no user confirmation):

# i2cdetect -y 9

Query the functionalities of I2C bus 1 (i2c-1):

# i2cdetect -F 1

Scan addresses 0x10 to 0x17 on the I2C bus named "SMBus I801 adapter at efa0", using the "receive byte" method, after user confirmation:

# i2cdetect -r "SMBus I801 adapter at efa0" 0x10 0x17

SEE ALSO¶

i2cdump(8), i2cget(8), i2cset(8), i2ctransfer(8), sensors-detect(8)

AUTHOR¶

Frodo Looijaard, Mark D. Studebaker and Jean Delvare

This manual page was originally written by Aurelien Jarno <aurel32@debian.org>, for the Debian GNU/Linux system.